Country Flame IWZC-02 User Manual download pdf (Page 31)

BLOWER OPERATION

Operation of the blower system is relatively simple. After the fire has generated enough heat, the

blower system will automatically turn on. The blower begins to operate because the Inglenook grate

area has reached approximately 110

F causing the installed snap disk to close thus energizing the

blower motor electrical circuit. Blower motor system operation could take longer than 20 minutes

depending on room temperature, outside temperature, and the size of the fire started in the Inglenook.

It is important to note that if the wall mounted blower speed control is installed and turned to low, the

blower’s speed will limit the amount of airflow that can be obtained as the blower motor begins

operation. Do not try to service the blower system unless you are a certified electrician. With the

blower motor system plugged into the receptacle and the electrical supply energized, an electrical

shock potential exists. The Inglenook lower compartment is labeled with Risk of Electrical Shock.

Disconnect Power Before servicing the Unit. Knowledge of electrical systems is required for

troubleshooting and servicing of the blower system.

In addition, the blower system has moving parts that may cause injury. Do not reach into the

lower grill area and try to determine if the blower is operating by touching or feeling for a vibration of

the motor. Reaching into the area of moving parts may cause injury. Never reach into the lower grill

compartment when the Inglenook Fireplace is being burnt as severe burns can occur from contact

with hot parts.

Version: 7.0

DANGER: Risk of Electric Shock. Disconnect Power Before Servicing The Blower Unit.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

No comments

Country Flame IWZC-02 User Manual Page 31