Version 4.0 47
APPENDIX C: TECHNICAL SPECIFICATIONS
Fuel Type: #2 Yellow Shelled Corn Fuel (CLEANED) Hardwood Pellet Fuel
Moisture Content: 14% or less (10- 12% preferred) A.P.F.I. residential fuel
Heat Content: 10,000 Btu/lb* Heat Content: 8200 BTU/lb
Ash Content: 3% maximum Ash Content: 1% max
Bulk Density: 40 lb./cubic ft. min
Moisture Content: 8% max
Size: 1/4” to 3/8” diameter
1.5” long max
Fines: 1% max through 1/8
th
screen
Hopper Size: 72 pounds corn or 55 pounds wood pellets
Flue Size: 4” recommended. If less than 10 feet use of 3 inch pipe is approved.
Flue Type: PL double wall vent with stainless steel inner liner
Air Inlet: 3 inch by .15 inch walled steel pipe
Auger Type: 1 1/8” cup Auger Feed System
Controls: Country Flame Intelli-Choice Control Board
Electrical: 120 Volts, 2.4 Amp, 60 Hz
Measurements: CROSSFIRE HEIGHT (at front) 22.5”
CROSSFIRE DEPTH (from shroud) 14.0”
CROSSFIRE WIDTH (rear) 26.0”
CROSSFIRE WIDTH (at shroud mount) 25.5”
Weight : STOVE WEIGHT 220 POUNDS
Clearances:
UNIT TO SIDEWALL 7”
UNIT TO SIDE TRIM 7”
UNIT TOP TO SIDE TRIM 9.25”
UNIT TOP TO MANTLE 9.25”
HEARTH FLOOR TO MANTLE 32”
NONCOMBUSTIBLE FLOOR PROTECTION (front) 6”
NONCOMBUSTIBLE FLOOR PROTECTION (sides) 6”
Shroud Measurements:
SHROUD WIDTH (standard) 42.0”
SHROUD HEIGHT (standard) 30.0”
SHROUD WIDTH (oversized) 48.0”
SHROUD HEIGHT (oversized) 32.5“
*BTU/lb can vary depending on the moisture content of the corn.
Comments to this Manuals